From Wikipedia, the free encyclopedia
Two M3s during Sherman tank repair in 26th British Armoured Brigade workshops in Perugia, Italy, 30 June 1944
A M3 is lifted out of a Sherman tank at 5th Indian Division's tank workshop near Taungtha, Burma, 29 March 1945
The US 75 mm gun tank gun M2 and the later M3 were the standard American tank guns of the , used primarily on the two main American
of the war, the
(M2 or M3 gun) and the
The lightweight M6 and M5 variants were developed to equip the
bomber respectively. The M3 was also used on the prototype
M2 75 mm gun as mounted in medium tank M3
The 75mm tank gun has its origins in the famous French
field gun of
fame which was also adopted by the United States and used well into World War II as the 75mm M1897 field gun. Both the tank and field guns fired the same range of 75x350R ammunition. The primary round was the M48 High Explosive. This 6.76 kg (14.9 lb) round travelled at 625 m/s (2,050 ft/s) and contained 1.5 pounds of TNT filling and choice of Super Quick (SQ) or Delay (PD) with 0.05 or 0.15 seconds of delay fuse. SQ was the standard setting with PD used against structures, gun positions or lightly protected vehicles. The field gun origins of the ordnance and ammunition ensured that the M2/3/6 series HE round was highly effective for its caliber. The M48 was available in 2 versions, standard or supercharge which increased the propellent charge for greater muzzle velocity (1,885 ft/s (575 m/s) vs. 1,470 ft/s (450 m/s)) and range (2,300 yards greater).
Other important rounds fired by the 75mm tank guns were the T30
for use against troops in the open at short range. This was essentially a giant shotgun shell full of large numbers of steel balls. Canister was used primarily in the Pacific. There was also the M88 base-ejecting smoke round and the M89 white phosphorus (WP or "Willy Pete") round which proved highly effective in the
fighting around . Finally there was the
for which two different rounds were provided.
The first armor-piercing round was the 6.32 kg (13.9 lb) M72 AP-T, a plain uncapped AP round whose performance dropped off as range increased due to poor aerodynamics. M72 was replaced by the 6.63 kg (14.62 lb) M61 and later the improved M61A1 APC Shell. This was actually an HE/APC-T type or rather an Armor Piercing Capped with Tracer filled with a small quantity of High Explosive. The aerodynamic ballistic cap acted as a windscreen and improved ballistic performance, maintained velocity, and retained penetration at longer ranges. The armor piercing cap, made of a softer metal, helped to prevent shell shatter at higher velocities and against sloped and "face-hardened" armor(FHA). Once the projectile had penetrated the target a small explosive charge at the base of the shell would detonate shattering the shell, and increasing damage inside the enemy vehicle. The tracer helped in aiming of a second shot. In practice the majority of M61 rounds were shipped without the explosive filler. M61 had a muzzle velocity of 617 m/s (0;ft/s) and was credited with the ability to penetrate 3.3 inches (84 mm) of Rolled Homogeneous Armor plate (0° from vertical) at 500 yards range, which was a quite acceptable performance by the standards of 1942. This ammunition type proved lethal to the Panzer III and IV (up to Ausf. F2) as these tanks were protected by a maximum of 50mm of FHA with little slope, which the 75 mm M3 was capable of penetrating from 1500 m. With the later[] Ausf. G iteration, the Panzer IV was rearmed with KwK 40 and its frontal hull armour increased up to 80mm, but its turret and gun mantlet retained their 50 mm thickness. This was compensated somewhat by the M4 Sherman's improved armor over the earlier M3 Lee making up for the 75 mm M3's diminishing b Wa Pruef 1 estimated that the M4's glacis was impenetrable to the KwK 40 when standing at a 30 degree side angle while the 75 mm M3 could penetrate the Ausf G's hull from 100 m in the same situation.
By July 1944 complaints started to pour in about the inadequate anti-tank performance of the M4 Medium tanks fitted with the 75mm M3 gun. During the breakout from Normandy American and British forces encountered the new generation of heavy German tanks and armored vehicles such as the ,
tank destroyer in quantity for the first time. These vehicles had thick frontal armor that proved largely immune to the M61 projectiles fired by the M3 tank gun and severely tarnished the reputation of the M4 Medium tank. The western allies countered by equipping increasing numbers of M4 Medium tanks with the
for the Americans and the
for the British. These guns offered much improved performance against tanks but because their High Explosive rounds were inferior the 75mm guns', the 76 mms never completely replaced the older models.
British tanks in the early years of World War II relied on high-velocity anti-tank guns such as the
for their primary armament. As tank guns these had the great disadvantage of either not having a truly effective High Explosive round or not even having a HE round at all. The British after experiencing the effectiveness of the American 75mm tank guns in the infantry support role opted to adopt the American caliber and ammunition by the expedient of boring-out the 6 pounder tank gun to make the . By 1944 this had become the standard British tank gun equipping the
for the campaigns in northwest Europe.
An M3 Grant with the 75 mm gun
An M4 Sherman with a 75 mm Gun M3
An M24 Chaffee with the 75 mm Gun M6
B-25H "Barbie III" showing 75mm M5 gun and 4 Browning 50 cal feeds
Used on the early .
Barrel length: 31
Muzzle velocity: 588 m/s (1,929 ft/s) with M72 AP shell
Shell weight (M72 AP): 6.32 kg (14 lbs)
Armour penetration (M72 AP shell, 100 m, at 30 degrees from vertical): 64 mm of FHA armour or 76 mm of RHA armour
Longer derivative of the M2. Equipped American and British vehicles such as the , the later models of the M3 Lee and the Churchill III/IV (scavenged from General Sherman tanks in the North African theatre). US Army also experimented with mounting of the M3 on various wheeled carriages for use as anti-tank gun, but the program was cancelled due to lack of requirement.
Barrel length: 40(37.5)
Muzzle velocity: 619 m/s (2,031 ft/s) with M72 AP shell
Shell weight (M72 AP): 6.32 kg (14 lbs)
Armour penetration (M72 AP shell, 100 m, at 30 degrees from vertical): 72 mm of FHA armour or 88 mm of RHA armour
Muzzle velocity: 617 m/s (2,024 ft/s) with M61 APC shell
Shell weight (M61 APC): 6.63 kg (14.62 lbs)
Armour penetration (M61 APC shell, 100 m, at 30 degrees from vertical): 77 mm of FHA armour or 76 mm of RHA armour
The 75-mm aircraft gun M4 is a modification of the M3 gun which is found in medium tanks. It differs from the M3 gun, only in having a seat for the spline machined in the tube. it was mounted on the M6 mount.
T13E1 / M5
A lightweight version of the M3 with a lighter thin-walled barrel and a different recoil mechanism that was used in the . Uses the same ammunition and has the same ballistics as the M3.
A version derived from the T13E1 for the .
Barrel length: 39
Muzzle velocity: 619 m/s (2,031 ft/s) with M72 AP shell
Shell weight (M72 AP): 6.32 kg (14 lbs)
Armour penetration (M72 AP shell, 100 m, at 30 degrees from vertical): 72 mm of FHA armour or 88 mm of RHA armour
Muzzle velocity: 617 m/s (2,024 ft/s) with M61 APC shell
Shell weight (M61 APC): 6.63 kg (14.62 lbs)
Armour penetration (M61 APC shell, 100 m, at 30 degrees from vertical): 77 mm of FHA armour or 76 mm of RHA armour
 : contemporary British tank gun
 : contemporary German tank gun
 : contemporary Soviet tank gun
Jentz, T Doyle, Hilary (2001). Panzerkampfwagen IV Ausf. G, H and J 1942-45. Osprey Publishing. pp. 20–21.  .
Jentz, T Doyle, Hilary (2001). Panzerkampfwagen IV Ausf. G, H and J 1942-45. Osprey Publishing. pp. 20–21.  .
Zaloga, Delf - US Anti-tank Artillery 1941-45, p 8-9
Zaloga, Steven J., Brian Delf - US Anti-tank Artillery 1941-45 (2005) Osprey Publishing (New Vanguard 107), .
TM 9-2800 Standard Artillery and Fire Control Material (dated February 1944)
Wikimedia Commons has media related to .
[] (search for Intelligence then Text Database of Penetration Data and select US guns)
: Hidden categories:化简（m+1)2（m2-m+1)2 (m6-m3+1)2_百度作业帮
拍照搜题，秒出答案
化简（m+1)2（m2-m+1)2 (m6-m3+1)2
化简（m+1)2（m2-m+1)2 (m6-m3+1)2
=【[(m＋1)(m²－m＋1)](m^6－m³＋1)】²=[(m³＋1)(m^6－m³＋1)]²=(m^9＋1)²=m^18＋2m^9＋1
=(（m+1)(m^2-m+1))^2(m^6-m3+1）^2=（(m^3+1)(m^6-m^3+1））……2=（m^9+1)^2=m^18+2m^9+1宝马M6百公里加速多少？_好搜问答
|注册&您有新任务，
宝马M6百公里加速多少？
被浏览30次
M3官方报的4.6S& 汽车之家实测4.9SM5官方报4.7S& 汽车之家测出来5.59SM6官方报4.6S&& 实际会是多少？
采纳率：45%
估计在5.2S左右 用微信扫描二维码分享至好友和朋友圈分享到：
下面是答答童鞋给您的小建议，您看靠谱吗？初来乍到，弄错了您不要生气哦(*^__^*)答答小贴士
等您帮助的附近的朋友换一换
大家都在搜好搜APP下载好搜摸字APP 随时随地随心搜索 用好搜， 特顺手！
第9天生活就像海洋，只有意志坚强的人才能达到生命的彼岸。知道了问一下是魅族M3音质好还是M6好，我不知道还选哪一个，所带的耳塞呢？谁的更好_百度知道
问一下是魅族M3音质好还是M6好，我不知道还选哪一个，所带的耳塞呢？谁的更好
提问者采纳
M3(飞芯版)低音较重M6的SL和TS较为均衡，M3不建议使用原装的耳塞，两者结合后低音过重希望采纳
其他类似问题
按默认排序
其他1条回答
您好，你好，综合性能、做工、配置、兼容性、性价比，推荐你购买魅族MX31，外观美观的，手感轻薄。亮屏那种动人心魄的效果，关屏浑然一体的黑，越看越想看。2，硬件配置：旗舰级的配置。魅族MX3是性能、散热、续航非常好的结合，给人敢玩、畅玩的体验。3，拍照：速度真快，真心的快。0秒延时拍照，20张每秒的高速连拍。超精简的相机设置，不会拍照的也能拍出好照片。尤其是在微距、夜景、白平衡上表现非常出色。4，音质超乎想象。5，魅族系统，界面效果好看、耐看。操作简单，界面逻辑性强，容易上手。您可以在如下链接查看MX3功能特色/技术指标：魅族在全国开设超过1000家实体认证店，售前售后更有保障。线上线下多渠道现货发售，全国统一售价。欢迎您到当地魅族认证店体验魅族手机。
魅族m3的相关知识
等待您来回答
下载知道APP
随时随地咨询
出门在外也不愁